Замена боковой подушки безопасности (Боковая подушка безопасности)
NOTE: Review the seat replacement procedure in the Body section before doing repairs or service.
Removal
| 1. | Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
|
| 2. | Disconnect the side airbag harness 2P connector (A).
|
| 4. | Remove the mounting nut (A) and the side airbag (B).
|
Installation
NOTE:
- If the side airbag lid is secured by a tape, remove the tape.
- Do not open the lid of the side airbag cover.
- Use new mounting nuts tightened to the specified torque. When you replace a side airbag.
- Make sure that the seat-back cover is installed properly. Improper installation may prevent proper deployment.
- Be sure to install the harness wires so that they are not pinched or interfering with other parts.
| 1. | Place the new side airbag on the seat-back frame (A). Tighten the side airbag mounting nut (B).
|
| 4. | Move the front seat and the seat-back through their full ranges of movement, making sure the harness wires are not pinched or interfering with other parts.
|
| 5. | Reconnect the battery negative cable.
|
| 6. | After installing the side airbag, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
|
