Регулировка направляющей полки (EPS)
Special Tools Required
Locknut wrench, 43 mm, ( 07MAA-SL00200)
EPS Model:
| 1. | Set the wheels in the straight ahead position.
|
| 2. | Loosen the rack guide screw locknut (A) with the special tool, then loosen the rack guide screw (B).
|
| 3. | Tighten the rack guide screw (A) to 25 N·m (2.5 kgf·m, 18 lbf·ft), then loosen it.
|
| 4. | Retighten the rack guide screw to 6.0 N·m ( 0.6 kgf·m, 4 lbf·ft), then back it off to specified angle.
| Specified Return Angle: | 10-20° Max. |
|
| 5. | Hold the rack guide screw stationary with a wrench, and tighten the locknut by hand until it's fully seated.
|
| 6. | Install the special tool on the locknut (B), and hold the rack guide screw stationary with a wrench.
Tighten the locknut to specified torque with the special tool.
|
| 7. | Check for unusual steering effort through the complete turning range.
|
